|
SAILOR SYSTEM 5000 500W D1 MF/HF is a fully MED Wheel-Mark approved GMDSS HF communication system for telephony, DSC and Telex.
When ease of use and high performance are crucial to daily communication and safety, this system is an indispensable tool for the professional seaman.
Developed to meet all requirements of the end user, ensuring easy, intuitive operation, while at the same time offering a cost effective, reliable and powerful system. Based on more than 50 years of creating the world’s most cutting edge communication equipment for the high seas. The unique combination of user friendliness and reliability makes the SAILOR System 5000 MF/HF one of a kind, suitable for all types of vessels around the world - from the smallest fishing vessel to the largest merchant vessel.
Consists of:
- Transceiver TU5500
- Control Unit CU5100 (blue)
- Antenna Tuner Unit ATU5515
- GENERAL
- Operating Modes: Simplex and semi-duplex SSB telephony and DSC, TELEX AM broadcast reception
- Frequency range: 150 kHz to 30 MHz (Rx)
- 1605 kHz to 30 MHz (Tx)
- Output power: 500W PEP ±1.4 dB into 50 ohm at 24V DC supply voltage voice
- Supply voltage: Nominal 24V DC floating
- With optional external AC power supply: 115/230V AC 50/60 Hz.
- Automatic change-over to DC in the absence of AC supply
- Power consumption: Rx, 60W (approx. at 24V DC)
- Tx, SSB speech: approx. 600W
- Tx, SSB two-tone: approx. 1100W
- Tx, DSC/TELEX: approx. 1200W
- Complies with ETSI 300-373 or better.
- Operating temperature range: -20°C to +50°C
- User-programmable channels: 199 frequency pairs with mode (1-199)
- User-programmable stations: 40 stations with name, MMSI and station channel
- RECEIVER
- Frequency range: 150 kHz to 30 MHz
- Aerial impedance: 50 ohm automatically matched by the aerial tuning unit
- Sensitivity: Aerial input for 10 dB SINAD, 50 ohm aerial:
- SSB tel.: 0.7 μV
- AM tel.: 4 μV
- DSC/Telex: 0.7 μV
- Complies with ETSI 300-373 or better.
- Audio output power: 4W with less than 10% distortion
- TRANSMITTER
- Output power: 1.6 to 3.999 MHz 400W PEP +0/-1,4 dB. voice, 4.0 to 29.999 MHz 500W PEP +/-1.4 dB. voice. 3dB Reduction when continuously keyed single tone, with duty cycle greater than 55% during 1 min.
- Automatic power recovery after 1 min.
- Power reduction: Low approx.: 10W
- Frequency range: ITU marine bands from 1605 kHz to 30 MHz
- DSC-TELEX MODEM
- DSC Equipment class: Class A
- Protocols: DSC: ITU-R M. 493.12, M. 541-6, and M. 1082.
- Telex: ITU-R M. 625-2 (incl. M. 476-4), M. 490, M. 491-1, and 492-5 NBDP telex in ARQ, FEC and SEL FEC modes
- Ship’s identity: DSC: 9-digit identity number
- Telex: 5- and/or 9-digit identity numbers
- Interfaces: Alarm: DSC distress alarm interface
- NMEA: NMEA 0183 interface for GPS equipment
- COM: PC interface for SCANCOMM telex control. RS-232, baud rate 9600 bps
- RCI: Remote transceiver control interface for control of frequency, mode and power level. T+Bus protocol, baud rate 2400 bps
- Line, Key: Transceiver AF line input/output and external key interface. -10 to +10 dBm, 600 ohm
- AUX alarm 2: Telex and non-distress/urgency DSC alarm output
- DSC WATCH RECEIVER
- Frequency range: Scanning: 2187.5 KHz, 4207.5 kHz, 6312.0 KHz, 8414.5 kHz, 12577.0 KHz, 16814.5 kHz
- Aerial impedance: 50 ohm Complies with ETSI 300-373 or better.
- AERIAL COUPLER
- Frequency range: 1.6 MHz - 27.5 MHz
- Aerial requirements: 8-18 m wire and/or whip aerial
- Aerial tuning: Fully automatic with no presetting
- Tuning speed: 0.1 - 8 sec Typical
- Power capability: 330W PEP in 50 ohm
- DIMENSIONS AND WEIGHT
- Transceiver Unit:
- Width: 390 mm (15.3”)
- Height: 445 mm (17.5”)
- Depth: 127 mm (5”)
- Weight: 19 kg (41.9 lbs)
- Antenna Tuning Unit:
- Width: 290 mm (11.4”)
- Height: 500 mm (19.7”)
- Depth: 80 mm (3.1”)
- Weight: 3.3 kg (7.3 lbs)
- Control Unit:
- Width: 200 mm (7.9”)
- Height: 100 mm (3.9”)
- Depth: 95 mm (3.7”) (incl. cable)
- Weight: 1.5 kg (3.3 lbs)
|
